In SONAR 8.5 and earlier this is found under Options > MIDI Devicesī. If you have a second VS-700R you will also want to enable "FANTOM VS (2-VS-700)".Ī. In SONAR's MIDI Devices menu, make sure you have enabled "FANTOM VS (VS-700)" under both Inputs and Outputs. Assign the Fantom VS Input and Output ports to "FANTOM VS (2-VS-700)" and click. In the second Fantom VS Editor, go to Setup > Setup MIDI Devices… In the Insert Soft Synth Options menu place a check mark next to "MIDI Source", "First Synth Audio Output" and "Synth Property Page". Insert a second instance by going to Insert > Soft Synth > Fantom VS (2) Assign the Fantom VS Input and Output ports to "FANTOM VS (VS-700)" and click In the Fantom VS Editor, go to Setup > Setup MIDI Devices.Į. In the Insert Soft Synth Options menu, place a check mark next to "MIDI Source", "First Synth Audio Output" and "Synth Property Page".ĭ. Insert the Fantom VS Editor by going to Insert > Soft Synth > Fantom VS.ī. To set this up properly do the following:Ī. Failure to configure this will result in the above error message. Make sure that Fantom VS Editor itself has its MIDI ports assigned properly. 32-bit SONAR with two VS-700Rs, you should have both "Fantom VS.dll" and "Fantom VS(2).dll" in C:\Program Files (x86)\Cakewalk\Vstplugins\Fantom VSģ. 32-bit SONAR with one VS-700R, you should only have one "Fantom VS.dll" in C:\Program Files (x86)\Cakewalk\Vstplugins\Fantom VSĭ.
64-bit SONAR with two VS-700Rs, you should have both "Fantom VS.dll" and "Fantom VS(2).dll" in C:\Program Files\Cakewalk\Vstplugins\Fantom VSĬ. 64-bit SONAR with one VS-700R, you should only have one "Fantom VS.dll" in C:\Program Files\Cakewalk\Vstplugins\Fantom VSī. If you have done this, you will want to remove the extra components from those locations or exclude them from your VST Scan options.Ī. Depending on the choices you selected when installing, you may have installed "Fantom VS.dll" and "Fantom VS (2).dll" into the following locations on your computer. Make sure that in SONAR's VST Scan options, you are not scanning more Fantom VS components than you have the physical hardware for. If SONAR cannot detect the Fantom VS hardware, then you will receive this error message.Ģ. Make sure the VS-700R is connected and powered on before starting SONAR and trying to insert the Fantom VS Editor.
To resolve this error message, please check the following settings very carefully:ġ. The error message refers to page 7 in the Fantom VS help document that discusses "Initial MIDI device settings in SONAR". This message is most likely related to configuration settings. If the display indicates 'Unable to read/write data'. When inserting the Fantom VS Editor into SONAR, you may receive the following error message:Ĭhoose Help - Fantom VS Editor Manual, and refer to 7.
0 kommentar(er)
